Don't just focus on battery life, these things related to new energy vehicles must also be paid attention to!
Release time:
2019-03-23
Zhongxin Jingwei Client, March 22 (Wu Qilong) - In the past two years, with the increase in the number of new energy vehicles, the quality issues of new energy vehicles have also become increasingly apparent. Data shows that a total of 136000 new energy vehicles were recalled in 2018. If compared with the sales of 1.008 million vehicles in the whole year, the recall proportion of new energy vehicles reached 13.5%.
Wu Qilong, March 3 -- In the past two years, with the increase in the number of new energy vehicles, the quality problems of new energy vehicles have gradually emerged. According to the data, a total of 22,2018 new energy vehicles were recalled in 13, and if the annual sales volume of 6.100 million units is compared, the recall rate of new energy vehicles reaches 8.13%.
Among the reasons for the recall of vehicles, battery problems account for a large proportion, and news about spontaneous combustion of new energy vehicles is also frequent. In 5, there were more than 2018 electric vehicle fire accidents in China, involving different models such as passenger cars, buses, and logistics vehicles.
Industry insiders analyzed that thermal runaway of new energy vehicle batteries is the most important cause of spontaneous combustion of vehicles. At this stage, electric vehicles continue to do high battery energy density in pursuit of longer mileage, but as the energy density increases, the probability of thermal runaway is also on the rise.

New energy concept car Zhongxin Jingwei Photo by Wu Qilong
Frequent spontaneous combustion problems of new energy vehicles A
few days ago, Shenzhen New Energy Vehicle Application and Promotion Center issued a notice saying that since the beginning of this year, Beiqi Weiwang 407 EV new energy pure electric trucks have had a number of safety accidents of spontaneous combustion in the local area, so the center decided to stop using the model. According to the notice issued by Shenzhen Zhaowei New Energy, on March 6, March 12 and March 16, three charging spontaneous combustion incidents occurred in various charging stations in Shenzhen.
The probability of battery fire in new energy vehicle accidents is much higher than that of traditional fuel vehicles. Statistics from the State Administration for Market Regulation show that there were more than 40 fires in China in 2018, especially during the hot weather in August and September.
According to the combing of the client of Zhongxin Jingwei, from August to September 2018 alone, nearly 10 spontaneous combustion accidents of new energy vehicles occurred in China. Among them, on August 17, a Jianghuai MPV model in Zhenjiang, Jiangsu Province spontaneously combusted. On August 25, a WM EX5 in Chengdu, Sichuan Province, spontaneously combusted in the WM Motor Research Institute Park. On August 26, an Ankai electric bus in Tongling, Anhui Province suddenly caught fire and burned while driving. On August 28, a charging van caught fire. On August 31, a Lifan 650EV caught fire in Guangzhou, Guangdong. On September 1, a Tesla in Changchun, Jilin Province was suspected to catch fire. On September 5, two Zotye Cloud 100 series shared electric vehicles in Zhuhai, Guangdong Province, caught fire while charging. On September 6, a Mercedes-Benz electric car caught fire in Hefei, Anhui Province. On September 10, a BYD electric car in Fuzhou, Fujian Province, spontaneously ignited after hitting a roadside guardrail.
In addition to the warmer months, spontaneous combustion accidents also occur from time to time. On October 10, 2018, a Changan Benben EV caught fire in Beijing's Haidian District. On October 12, a Jianghuai Ruifeng MPV on a highway in Chongqing spontaneously combusted. On November 21, a Jianghuai pickup truck in Jining, Shandong Province, spontaneously combusted while driving normally on the road. On January 25, 2019, a normal driving JAC new energy vehicle in Yongcheng, Henan Province, suddenly spontaneously ignited while waiting for a red light.
Battery thermal runaway is the main cause of spontaneous combustion The
frequent spontaneous combustion of new energy vehicles has to let the industry deeply explore the technical and quality issues behind it. Previously, the research institute EVTank released the "China Electric Vehicle Market Research Report", which made incomplete statistics and sorting out the safety accidents of electric vehicles in China. The "Report" shows that the main cause of safety accidents in electric vehicles is related to power batteries, and most vehicles spontaneously combust during charging.
The analysis and statistics of new energy vehicle fire accidents by the Prospective Industry Research Institute since 2017 also show that the charging scene is the high-incidence scene of fire, accounting for 50%. Among the causes of fire accidents, spontaneous combustion of power batteries accounted for 31%, mainly due to the internal or external short circuit of lithium batteries, the battery released a lot of heat in a short period of time, and the temperature rose sharply, resulting in thermal runaway.
Liu Sichang, a researcher in the new energy industry of power equipment of Industrial Securities, pointed out in an interview with the client that thermal runaway of batteries is the main cause of spontaneous combustion of batteries of new energy vehicles, because the battery will release a lot of heat during high-power discharge, if the structure of the battery itself is unreasonable or the pouch battery with poor heat dissipation performance is indeed prone to thermal runaway when there are defects in the design or work of the battery heat treatment system.
"It may also be the failure of the battery structure", Liu Sichang further explained, for example, the positive and negative electrodes of the battery may break down short circuit and cause battery flatulence, flatulence may cause battery leakage, and then cause a wider range of short circuit, resulting in spontaneous combustion of the vehicle.
Ouyang Minggao, an expert in automotive power systems and academician of the Chinese Academy of Sciences, also clearly pointed out that electric vehicles have now reduced the thickness of the separator in the battery in order to pursue high energy density and high endurance, which has affected battery safety and is easy to cause thermal runaway.
Why is there a greater probability of spontaneous combustion when charging? Liu Sichang explained that the situation is similar to when charging and discharging, especially when using a high-power charger for fast charging, the line itself will heat up. In addition, when the charging current is large, the migration of electrons inside the battery is also relatively large, and the battery itself will also be dissipated, and the heat released by high-power charging is higher than that of high-power discharge.
Another insider pointed out that due to the vehicle's pursuit of cruising range improvement, the insufficient verification work done before the use of high-energy density batteries is also an important reason for spontaneous combustion of batteries. "As long as the battery meets the national standards and passes the corresponding testing procedures, the products produced and used should be qualified products." Liu Sichang said that there may be certain defects in verification, but it may also be that after the battery density is too high, its own instability has buried the hidden danger of spontaneous combustion.
Do not blindly pursue high energy density The
client noted that the NEV subsidy policy implemented in June 2018 stipulates that pure electric vehicles with a cruising range of less than 150 kilometers are not eligible for subsidies. The subsidy for models with a cruising range of 150-300 kilometers will be reduced by 20% to 50% respectively; For models with a cruising range of more than 300 kilometers, the subsidy will be increased by 2% to 14%.
At the same time, the new subsidy policy also puts forward requirements for the energy density of power batteries, and the energy density of pure electric vehicle batteries cannot be lower than 105Wh/kg. For models with an energy density of 105-120Wh/kg, the subsidy is 0.6 times that before the adjustment; for models with an energy density of 120-140Wh/kg, the subsidy is maintained at the price before the adjustment; The subsidy for models with an energy density of 140-160Wh/kg is 1.1 times that before adjustment; for models with an energy density of 160Wh/kg and above, the subsidy is 1.2 times that before adjustment.
Although the latest new energy subsidy standards have not yet been released this year, the subsidy policy implemented since last year has clearly favored the use of high-energy-density batteries and high-endurance models. This move will undoubtedly guide car companies to use high-density batteries as soon as possible.
"There is no problem in linking subsidies to the energy density of power batteries, but it must conform to the objective development law of technology, and the pace of development of new energy vehicles should be stable." Ouyang Minggao said that the frequent adjustment of the subsidy policy is not conducive to product quality verification, and the subsidy policy changes every year, which does not match the product development cycle.
"The development cycle of power battery material improvement generally takes 24-28 months, and some companies blindly pursue high energy density in order to obtain subsidies, which will shorten the test and verification time, and then cause potential safety hazards." Ouyang Minggao said.
Liu Sichang analyzed that the current subsidy policy does intend to guide the battery energy density in a higher direction, but the follow-up policy is likely not to further encourage ultra-high energy density batteries, because the safety and stability of high-density batteries are indeed safety hazards in the current situation.
"The energy density of power batteries is generally divided into two types: volumetric energy density and mass energy density." Liu Sichang further explained that the more commonly used mass energy density refers to the proportion of metals that can provide electrons per unit mass. Lithium batteries have the advantage because the density of lithium is small, so under the same mass, the higher the proportion of lithium in the battery, the greater the energy density of the battery. However, lithium is a relatively active metal, and its unstable and other unfavorable factors will increase with the increase of proportion. "Battery energy density and safety are mutually reinforcing." Liu Sichang said.
"Battery energy density is not only closely related to vehicle safety, but also causes an increase in production costs for enterprises, and if the energy density is continuously increased, a lot of R&D, production line transformation and other costs are required." Liu Sichang said frankly.
Industry recommends unified quality inspection standards According
to public data, in 2018, eight automakers, including BAIC New Energy, recalled a total of 136,000 new energy vehicles. In fact, at present, there is no unified industry standard for the identification of power battery quality problems, and each car company and battery manufacturer has its own set of testing standards, and if they test the product and think that there is a problem, they may be recalled or repaired.
Recently, the State Administration for Market Regulation issued the Notice on Further Strengthening the Management of New Energy Vehicle Product Recalls, requiring relevant manufacturers to immediately organize investigation and analysis after learning of traffic collisions, fires and other related accidents in the Chinese market of new energy vehicles produced, sold or imported, and report the results of the investigation and analysis to the State Administration for Market Regulation.
The Notice also clarifies that manufacturers of parts and components such as power batteries, motors and electronic control systems who learn that new energy vehicles may have defects should report to the State Administration for Market Regulation (Quality Development Bureau) and notify the manufacturer. At the same time, cooperate with defect investigation, recall implementation and other related work.
"It is hoped that the relevant departments of the state can introduce unified quality inspection standards for power batteries and their performance in all aspects for the industry." Liu Sichang said that due to the current power battery models, a wide variety, and different testing standards, the testing work is relatively complicated. But if the policies and standards are improved, it will be easier for car companies to implement, and relevant tests can be based on, so that safety hazards caused by battery quality and other problems can be minimized before the sale of new energy vehicles.
In addition, due to the high cost of replacing batteries in new energy vehicles, many car owners are more concerned about battery maintenance. In this regard, the "Electric Vehicle Safety Guidelines" recommends that the battery's charging, airtightness, insulation performance and appearance be checked every 5,000 kilometers or half a year.
"The most ideal maintenance method for power batteries is 'shallow charge and shallow discharge' during use", Liu Sichang pointed out, "The battery should not be deeply discharged when in use, and try to choose slow charging." The best charge and discharge range to extend battery life is 30%-70%, and if you can stick to it, the current ternary lithium battery can basically be achieved5,000 charge-discharge cycles". (Zhongxin Jingwei APP)
Related News